KU LNA BB 1020 A, Low Noise Broadband Amplifier
1000 ... 2000 MHz
Lead time on request
| Frequency range | 1000..2000 MHz |
| Noise figure @ 18 °C | typ. 0.8 dB, max. 1.0 dB NF |
| Gain | min. 28 dB |
| Maximum input power | 10 mW |
| Output power (P1dB) | typ. 200 mW (+23 dBm) |
| Output IP3 | typ. +37 dBm |
| Input return loss (S11) | min. 10 dB |
| Output return loss (S22) | typ. 10 dB |
| Supply voltage | +12 ... 15 V DC |
| Current consumption | typ. 350 mA |
| Operating case temp. range | -20 ... +65°C |
| Input connector / impedance | SMA-female, 50 ohms |
| Output connector / impedance | SMA-female, 50 ohms |
| Case | milled aluminium |
| Dimensions (mm) | 78 x 41 x 22 |
| Weight | 100 g (typ.) |
This high linear preamplifier was developed in 1…2 GHz directional radio link. It is suitable especially for applications where a high intermodulation distortion ratio and at the same time a high input sensitivity are used. As example for RADAR preamplifiers or for digital directional radio distance with DVBT-DVBS-COFDM and QPSK modulation. The coupling happend through 3dB hybrids, which guarantee an excellent input SWR and linearity of the preamplifier. A high stimulus capability and simultaneously a low noise figure makes the preamplifier for many applications usable. The voltage supply via coax cable (remote power supply) or direct at the case is possible.
- Low noise figure
- High IP3
- Good input return loss (S11)
- Static protection (ESD) at preamplifier input
- Overvoltage protection and reverse polarity protection
- Remote power supply via output connector
- Solder pin for direct power supply
- Analog and digital transmission systems
- Measurement and laboratory equipment
- Amplifier does not contain a coaxial relay!
- Maximum input power 10 mW
