MKU PA 2M-60W HY-2, VHF-MOSFET Power Amplifier
144 ... 146 MHz • 60 W
VHF MOSFET Power Amplifier for the Amateur Radio Band 2 m
Designed for usage with SDR Flex 6700
VHF MOSFET Power Amplifier for the Amateur Radio Band 2 m
Designed for usage with SDR Flex 6700
| Frequency range | 144..146 MHz |
| Input power | typ. 5 mW |
| Maximum input power | 8 dBm |
| Saturation power | typ. 60 W |
| Gain | 41 dB (typ.) |
| Harmonic rejection | typ. 60 dB |
| Supply voltage | +12 ... 14 V DC |
| Quiescent current | typ. 4 A |
| Current consumption | max. 12 A |
| Operating case temp. range | -20 ... +55 °C |
| VSWR of load | max. 1.8 : 1 |
| Input connector / impedance | SMA-female / 50 ohms |
| Output connector / impedance | N-female / 50 Ohms |
| Case | milled aluminium |
| Dimensions (mm) | 130 x 60 x 20 |
| Weight | 270 g (typ.) |
- Good linearity
- Built-in low pass filter for good harmonic rejection
- Reverse polarity protection
- Monitor outputs for forward and reverse power detection
- Analog transmissions systems
- Power amplifier for radio amateur applications (SSB, CW)
- Designed for usage with SDR Flex 6700
Please notice the following:
- Recommended output power for radio amateur applications: Modulation type: CW/FM up to 60 W, SSB up to 20 W
- The technical specifications refer to room temperature.
- The power amplifier doesn’t contain any coaxial relays.
- The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
- Further information about dimensioning of heat sinks is available on our FAQ site.
Please notice the following:Recommended output power for radio amateur applications: Modulation type: CW/FM up to 60 W, SSB up to 20 W
The technical specifications refer to room temperature.
The power amplifier doesn’t contain any coaxial relays.
The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
Further information about dimensioning of heat sinks is available on our FAQ site.
The technical specifications refer to room temperature.
The power amplifier doesn’t contain any coaxial relays.
The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
Further information about dimensioning of heat sinks is available on our FAQ site.
